1.
Remove lid from tube
Once the tubes are firmly in place, attach the sticker provided over the vent hole.
2.
Remove inner (white) tube and place on a flat surface with open end facing upward.
3.
Fill the white tube with ashes (using a funnel if required)
Turn the sealed tube over and place the lid on, ensuring that any pattern is aligned.
Squeeze a generous line of glue around the inside circumference of the outer tube (This one is colour printed & has a hole in the base) approximately 2.5 cm / 1 inch below the rim.
To scatter ashes, take the lid off and push out the perforated disc.
Line up the openings of both tubes and push the outer tube downwards slowly, to allow air to escape through the vent hole.